How to connect UniRec* universal receivers to Hormann Tubauto Procom 7

New products

Creasol DomBus37: 12 analog/digital inputs, 3 AC inputs and 3 relay outputs for building automations
Creasol DomBus36 - 12 relays DIN-rail module with very low power consumption - DomBus and Modbus protocols
Creasol DomBusEVSE: smart electric vehicle charging controller for home made DIY wallbox
Creasol DomBusTH: domotic module with temperature+humidity+touch sensors, 3 LEDs, 4 inputs, 2 outputs (also configurable as inputs)
Creasol DomBus31: 8 relays module for home automation system, with very low power consumption
Creasol DomBus12: compact module for home automation system, with 9 configurable I/O
Creasol DomBus23: Smart Home RS485 module with 2x relays, 1x mosfet with dimming function, 2x I/Os, 2x 0-10V analog outputs that can be configured as open-drain outputs, 2x 12/24V opto inputs, 1x 230V opto input
Creasol DomBus33 - Smart light controller, with 3 relay outputs, 3 AC inputs, 5 I/Os

News

Details: Category: Universal receivers; Last Updated: 11 August 2017

Our compact universal receiver UniRec1 should be connected to HORMANN / TUBAUTO automation in this way:

UniRec1 should be connected in this way:
* connect 1 supply wire to terminal 5
* connect the other supply wire to terminal 20
* connect Switch+ wire to terminal 21
* connect Switch- wire to terminal 20

If you plan to use our 2 channel UniRec2 receiver, just connect power supply to terminals 5 and 20, and relay outputs to terminals 21 and 20: with UniRec2 you should not care about polarity.

This schema is valid even for Garador Garamatic 9