The following instructions to connect the universal receiver UniRec1 to the gate operator PowerTech PW320.
The scope of this installation is to open the powertech gate from another kind of remote control. In other words, I'd like to control more automations using a single remote control.
* Connect one Supply wire to GND terminal block
* Connect another Supply wire to 24V terminal block
* Connect Switch+ wire to DKEY terminal block
* Connect Switch- wire to GND terminal block
Then, set the frequency of UniRec1 (if different from 433.92 MHz), and learn your remote controls.
New and updated products
News
- Suggestions: what to prepare in a new (or renovated) home to be able to automate it
- FAQ veicoli elettrici e fotovoltaico
- Connecting a network of DomBus modules through TCP (WiFi, Ethernet, ...) or wireless radio link
- Making a DIY homemade Smart Wallbox working with Home Assistant to charge electric vehicles
- Creasol DomBusGateway: DomBus 2 MQTT bridge for HomeAssistant, NodeRED, OpenHAB, ioBroker, MQTT...
- Installing an optimized Rasbian + Domoticz image on Raspberry PI4 or PI3
- CR2032 Lithium-Manganese battey passivation layer
- Creasol DomBus and Home Assistant
- Hourly electricity prices and costs, solar photovoltaic energy production forecast and Power System Flexibility: Domoticz script
- Domoticz, reliable free and open source home automation system
- Free domotic system controlling heat pump to optimize power consumption from photovoltaic
- Connecting UniRec1 receiver to Berner GA 103 or GA 203 or GA 403 motor driver to use any remote control with Berner automations
Support
How to connect UniRec1 receiver to PowerTech gate operator
The following instructions to connect the universal receiver UniRec1 to the gate operator PowerTech PW320.
The scope of this installation is to open the powertech gate from another kind of remote control. In other words, I'd like to control more automations using a single remote control.
* Connect one Supply wire to GND terminal block
* Connect another Supply wire to 24V terminal block
* Connect Switch+ wire to DKEY terminal block
* Connect Switch- wire to GND terminal block
Then, set the frequency of UniRec1 (if different from 433.92 MHz), and learn your remote controls.
