Creasol Four4 - Remote control transmitter and duplicator 433.920 MHz

Remote controls

Copy almost any remote control for gates, garage doors, barriers, which transmit a fixed code in the frequency 433.92 MHz with OOK/ASK modulation. Each button is independent, so it's possible to clone up to 4 different remote controls, even if made by different manufacturers.

Creasol Four4 remote control duplicator 433.920 MHz long rangeThe remote control is provided with a factory programmed unique code, CR2032 battery already installed, with a snap hook and 2 years warranty.
Everything is packed in a nice transparent resealable clamshell with multi-language manual.

Duplication

Duplication is very very easy, and does NOT require any external equipment (frequency counter, programming machine, sniffer):

  1. Press together buttons 1 and 2, until LED becomes green.
  2. Release all buttons.
  3. Press and release the button where you wish to duplicate the original remote control.
  4. Start to transmit by pressing and holding the button on the original remote control, keeping it at 5-10cm of distance from the duplicator.

When duplication ends, LED flashes 2 times in case of fixed code, or 4 times in case of rolling code. Then LED becomes green and duplication procedure restart from point 3 to copy a new remote control.

In case that led flashed 4 times (rolling code), the duplicated code may not work.

 After duplication, please test that code was copied correctly and that it's really a fixed code, by transmitting at least twice to assure that the gate or garage door reacts correctly to both transmissions.

Initialization of a random 32 bit code

Follow the instructions below to set a new random code on one or more buttons:

  1. Press together buttons 3 and 4, for about 5 seconds, until LED becomes green.
  2. Release all buttons.
  3. Press twice the button where you wish to initialize the code.

The remote control emits 2 flashes, then it's possible to program a new button with a new random code repeating the procedure from point 3.

This feature is useful mainly for two reasons:

  • Remove a previously stored code from the remote control, for example after showing duplication procedure to a customer.
  • Program a random code that may be used with a universal receiver.

Battery status and replacement

If, during transmission or duplication, both LEDs blink (red and green), the battery voltage is low: in this case the battery should be flat, or the temperature too low. In the first case, the enclosure should be opened loosening the 2 screws, picking up the board and replacing the existing battery with a new CR2032 Lithium cell (3V 210mAh).creFour_blister_150

Product look

The remote control is provided with a factory programmed unique code, CR2032 battery already installed, with a snap hook, ready to use and 2 years warranty.
Everything is packed in a nice transparent resealable clamshell with multi-language manual.

Companies who'd like to distribute our products can ask for customized instructions with the preferred languages, brand, model name and logo.

Other documents

You may also like