Creasol UniRec1 universal receiver can be connected to the SCS SENTINEL board ACCESS-602 to allow controlling that board by another kind of remote control, for example to use a single remote control to open more than one automation.
Connect one Power Supply wire to terminal 11
Connect the other Power Supply wire to terminal 12
Connect Switch+ to terminal 4
Connect Switch- to terminal 3
Then, program the receiver to learn one or more remote controls, and check that it works.
If it does not open the automation, exchange the connections to terminal 4 with terminal 3, and vice versa.
New and updated products
News
- Prix et coûts horaires de l'électricité pour les pays de l'UE et prévisions de production d'énergie solaire photovoltaïque : script Domoticz
- FAQ veicoli elettrici e fotovoltaico
- Installation d'une image Rasbian + Domoticz optimisée sur Raspberry Pi 3, Pi 4 ou Pi 5
- Intégration du système d'éclairage utilisant des relais pas à pas dans Home Assistant, Domoticz, ...
- Connexion d'un réseau de modules DomBus via TCP (WiFi, Ethernet, ...) ou liaison radio sans fil
- Comment construire un système domotique à l'aide de modules DomBus
- Creasol DomBusGateway : Pont DomBus 2 MQTT pour HomeAssistant, NodeRED, OpenHAB, ioBroker, MQTT...
- Fabriquer une wallbox intelligente faite maison en utilisant Home Assistant pour recharger les véhicules électriques
- Suggestions: que préparer dans une maison neuve (ou rénovée) pour pouvoir l'automatiser
- CR2032 Lithium-Manganese battey passivation layer
- Creasol DomBus and Home Assistant
- Domoticz, système domotique fiable, gratuit et open source
How to connect UniRec1 to SCS-SENTINEL ACCESS 602 CTRL 51
Creasol UniRec1 universal receiver can be connected to the SCS SENTINEL board ACCESS-602 to allow controlling that board by another kind of remote control, for example to use a single remote control to open more than one automation.
Connect one Power Supply wire to terminal 11
Connect the other Power Supply wire to terminal 12
Connect Switch+ to terminal 4
Connect Switch- to terminal 3
Then, program the receiver to learn one or more remote controls, and check that it works.
If it does not open the automation, exchange the connections to terminal 4 with terminal 3, and vice versa.
